Bosch TC900 Concrete Screw Drill Set

Bosch TC900 Concrete Screw Drill Set Review

Bosch TC900 Concrete Screw Drill Set Feature

• Bosch not only has a rich heritage in concrete, but is the largest manufacturer of concrete drill bits in the world
• Complete program including all sizes, the bit holder, the bit sleeve, and a complete anchoring system
• Magnetic nut setters hold the screw in place, and keep the sleeve from being damaged, extending the life of the entire system
• Bosch holds the tightest dimension to ensure low run out

With the Bosch TC900 9-Piece Masonry Screw Drill Set, all you do is insert a drill bit into the mandrel and tighten it down with the included hex wrench. The bits have a flat side to the shank so there’s no spinning once the torque kicks in, as can happen with an ordinary masonry bit. Then you insert the proper size hex driver or Phillips-head driver into the TC900 sleeve and you’re set. Once the hole is drilled, simply slide the sleeve over the bit, locking the driver in place, and proceed to drive in either a Phillips flat head or Tapcon® hex head anchor. Pull off the sleeve, exposing the bit, and repeat the process. It’s as close to fun as you’re going to get.

Features:

• Complete program including all sizes, the bit holder, the bit sleeve, and a complete anchoring system
• Magnetic nut setters hold the screw in place, and keep the sleeve from being damaged, extending the life of the entire system

What's In The Box:

• Masonry Screw Drill Bit Holder
• Allen Wrench
• Drill Bit Sleeve
• 5/32-inch Flat-Shank Carbide Drill Bit
• 3/16-inch Flat-Shank Carbide Drill Bit
• Two Magnetic Nutsetters
• Two Phillips Head Bits
• Brute Tough Snap Storage Case